Datecs DPP-450 Manual do Utilizador descarregar pdf (Página 7)

DATECS DPP-450 Programmer’s Manual

Press longer than 1 sec.: Feed paper to find next black mark.

(Same as sending FF command)

- Remarks for programming

As it is possible to print on black mark, if user does not want to print on the black mark, it have to be

taken care by user side program

- Remarks on handling

If the paper cover is open in black mark mode, there is a possibility to recognize it as detecting black

mark.

5. The operation of the command depends on the state of the configuration flags 2, 3 and 4 (CR)

Code: [0Dh]

This command is ignored or its action is the same as LF depending on the state of memory switches

2, 3 and 4, set using last command GS ).

6. Image LSB/MSB select (DC2 =)

Code: [12h] + [3Dh] + n

The command selects whether the left edge of print image is the LSB or MSB for commands GS *,

DC3

F and DC3 v. n is from 0 to FFh, but only least significant bit checked:

0: LSB is the left edge.

1: MSB is the left edge.

Default is 1.

7. DC3 (Ruled line) commands sequence start (DC3 ( )

Code: [13h] + [28h]

Following this command the printer receives DC3 commands without DC3 symbol at the beginning.

The symbol ‘)’ ends the sequence. All commands, which are not DC3 commands, are ignored.

8. Sets the ruled line ON (DC3 +)

Code: [13h] + [2Bh]

After receiving this command every printed line is combined with the selected ruled line buffer. This

happens when commands LF, ESC J, ESC d, DC3 P, DC3 p are executed. Depending on last command

DC3 M executed the ruled line buffer is combined with the text using OR (if there is a bit ‘1’ in ruled

line buffer, a black dot is printed) or XOR (if there is a bit ‘1’ in ruled line buffer, then the

corresponding dot is inverted).

All DC3 command except DC3 P and DC3 p are executed when ruled line mode is off, too. Su the

ruled line buffers can be cleared or set before this command.

The command DC3 – sets ruled lines off.

In page mode nothing is printed outside the selected using ESC W region.

The command does not clear rule line buffers.

By default ruled lines are disabled.

9. Sets the ruled line OFF (DC3 -)

Code: [13h] + [2Dh]

The command disables ruled line mode.

All DC3 command except DC3 P and DC3 p are executed when ruled line mode is off, too. Su the

ruled line buffers can be cleared or set after this command.

The command DC3 + sets ruled lines on.

The command does not clear rule line buffers.

By default ruled lines are disabled.

1 2 3 4 5 6 7 8 9 10 11 12 ... 37 38

Comentários a estes Manuais

Sem comentários

Datecs DPP-450 Manual do Utilizador Página 7

Comentários a estes Manuais

Manuais e produtos relacionados com Digitalizar e Imprimir Datecs DPP-450