Datecs DPP-450 Manual do Utilizador descarregar pdf (Página 36)

DATECS DPP-450 Programmer’s Manual

to 16.

Size (multiplication) in vertical direction. 1 to

16.

Attr

Print attributes. One byte from 0 to 255. Each bit of Attr indicates

the following:

Bit

Function Value 0 Value 1

Font size А (12x24 or 24x24)

B (9x16 or 16x16)

Not used

Bold

Enabled Disabled

Not used

Data. Bytes with ASCII codes below 20h are

ignored.

X and Y coordinates are xL+256*xH and yL+256*yH.

The currently active page direction, country and code table are used. From all print attributes

only BOLD is used.

After every printed symbol X coordinate is automatically increased by symbol width +

character space, multiplied by sX. If some part of the symbol is not in the selected page area,

the symbol is not printed.

The command is executed in page mode only.

The command is supported in firmware version 1.48 or higher.

106. Specifying printing mode of two-byte text data (FS !)

Code [1Ch] + [21h] + n

Data is given in binary

code. Each n bit

indicates the following:

Bit Function Value 0 Value 1

Font size 24x24 16x16

Undefined

Double Height Canceled Specified

Double Width Canceled Specified

5 Undefined

6 Undefined

7 Underline Canceled Specified

An underline is attached to the full character width, which, however, is not attached to the

part

1 2 ... 31 32 33 34 35 36 37 38

Sem comentários

Datecs DPP-450 Manual do Utilizador Página 36