
Horizontal Tab command configuration flags 2, 3 and 4
Printing а line and Paper Feeding command
Printing and paper feeding to the black mark position
The operation of the command depends on the state of the
( DC3 (Ruled line) commands sequence start
Clears selected ruled line buffer
Sets a single dot in selected ruled line buffer
Selects ruled line combine mode
Ruled line 1 dot line print
Ruled line n dots line print
Canceling print data in page mode
Printing data in page mode
Setting character spacing
Setting EURO symbol position
Specifying the absolute horizontal position of printing
Selecting/Canceling the printing of downloaded user character sets
Selecting user character set
Specifying printing mode of text data
Selecting/Canceling underlining
Printing self test/diagnostic information
Specifying 1/6-inch line feed rate
Specifying line feed rate n/203 inches
Changes print direction to opposite
Selecting print direction
Black mark mode sensor calibration
Setting horizontal tab position
Specifying/Canceling highlighting
Filling or inverting the page area in page mode
Specifying/Canceling highlighting
Specifying/Canceling Italic print
Printing and Paper feed n/203 inches
Reading programmed serial number
Specifying speed (bps) of the serial port
Selecting/Canceling underlined printing
Selecting/Canceling printing 90°- right turned characters
Defining the print area in page mode
Specifying max printing speed
Selecting intensity level
Returning diagnostic information
Specifying relative horizontal position
Loading the default settings stored in Flash memory
Saving current settings in Flash memory
Comentários a estes Manuais